Remap Stage 2/3 gasolina turbo para hardware modificado. Ganancias máximas con upgrades de soporte.
A Stage 2 or Stage 3 petrol turbo remap is a high-performance ECU calibration built for turbocharged and supercharged petrol engines that have been fitted with aftermarket hardware upgrades. This is not a bolt-on tune for stock vehicles — it is a custom calibration engineered to match the specific combination of performance parts installed on your car.
Where a Stage 1 remap works within the limits of factory hardware, Stage 2 and Stage 3 calibrations unlock the additional airflow, fueling, and boost capacity provided by upgraded components. Power gains of 25–45% over stock are achievable, depending on the platform and the extent of the modifications.
The tuning process starts with your original ECU file and a detailed list of the hardware modifications on your vehicle. Our calibration engineers then adjust boost pressure targets, fuel injection timing and duration, ignition advance maps, cam timing (where applicable), and torque limiter values to safely exploit the additional capacity of your upgraded hardware.
Stage 2 calibrations are typically designed for vehicles with a performance downpipe or decat, an upgraded intercooler, and a high-flow intake. Stage 3 goes further, targeting builds with hybrid or upgraded turbochargers, uprated fuel injectors, high-pressure fuel pumps, and often forged internals. Each calibration is built individually — there are no generic maps at this level.
The most obvious benefit is a substantial increase in power and torque that transforms the driving experience. But beyond the headline numbers, a properly calibrated Stage 2/3 file delivers smooth power delivery, optimized boost response, and safe air-fuel ratios under all conditions. The engine runs cleanly and reliably at the higher output levels because the software is matched to the hardware.
Knock safety margins are carefully maintained through conservative ignition timing in high-load cells, and fuel enrichment strategies protect the engine during sustained high-boost operation. This is precision engineering, not a crude boost increase.
Stage 2 requires at minimum a performance downpipe (or decat), an upgraded intercooler, and a high-flow air intake. Stage 3 builds typically include a hybrid or larger turbocharger, uprated fuel injectors, a high-pressure fuel pump upgrade, and often forged pistons and connecting rods for engines targeting very high power levels. A reinforced clutch or upgraded torque converter is strongly recommended for both stages.
Submit your original ECU file along with a complete list of your hardware modifications. Our engineers will confirm the appropriate stage, discuss target power levels if needed, and deliver a custom calibration file — typically within 1–2 hours. Checksum correction is included, and the file is ready to flash immediately.
Stage 2 es para vehículos con escape deportivo, intercooler mejorado y admisión. Stage 3 apunta a builds con turbo híbrido o más grande, sistema de combustible reforzado y a menudo pistones forjados.
No. Estas calibraciones están diseñadas para upgrades de hardware específicos. Usarlas en un vehículo de serie puede causar daños al motor. Un remap Stage 1 es la opción correcta para vehículos sin modificar.
25–45% de ganancia sobre serie es típico. Por ejemplo, un 2.0 TFSI de 220cv puede alcanzar 300-320cv en Stage 2 con el hardware apropiado.
Recomendamos 98/99 RON (o E85 si tu sistema lo soporta) para calibraciones Stage 2/3.
Los archivos Stage 2/3 gasolina turbo se entregan normalmente en 1–2 horas en horario laboral.